Your Language:

Hörmann Ecostar Rail FS-3(-M) rail end stop

14,96
Add to Compare
Availability
In stock
  • Mechanical end stop for rail.

  • Suitable for multiple models
  • Contact us for large amounts (100+)

  • Unlimited online support

Mechanical end stop suitable for several types of Hörmann rails.

The end stops inform the Hörmann garage door operator in which position the door is fully open and closed. One for the gate open position, one for the gate closed position, so normally two end stops are needed.

When the door is installed, the Hörmann end stop is first loosely inserted into the guide rail between the guide carriage and the operator. Then push the gate by hand into the open end position and attach the end stop.

For the gate closed position, insert the end stop into the guide rail between the guide carriage and the gate and push the gate by hand into the gate closed end position. Now push the end stop approximately 10 mm further towards the gate and secure it there.

If the garage door does not reach the full passage height in the end position, the rear end stop can be omitted and the stop integrated in the drive head can be used instead.

Suitable for rails:

Hörmann FS 2.
Hörmann FS 3-M.
Hörmann FS 10.

Suitable for the drives:

Hörmann BerryMatic
Hörmann EcoMatic
Hörmann EcoStar Liftonic 700
Hörmann EcoStar Liftonic 800
Hörmann EcoStar Liftonic 700 II
Hörmann EcoStar Liftonic 800 II
Hörmann ITO 400
Hörmann ProMatic
Hörmann ProMatic Akku
Hörmann ProMatic P
Hörmann SupraMaric E.
Hörmann SupraMaric P.

Scope of delivery:

1 piece. (normally 2 pieces required)

General

Brand Hörmann