Remote Sommer Pearl Status with 4 buttons (3 channels)
This bidirectional 4-channel remote on 868MHz rolling is super secure thanks to the 128 bit AES encryption. This transmitter can send and receive: when your signal is picked up by the receiver, the Pearl Vibe will vibrate so you know the door is really opening or closing.
Also known as:
Pearl Status
TRX55-868-4 (NOTE: this number isn't used for remotes anymore)
S10448-00004
Hop-function: Every SOMloq2 receiver sends recognized commands through for max. 2 times.
Pearl Status remotes have a gate position indicator.
The before mentioned functions only work when using a new SOMloq2 receiver that has been configured for these signals.
NOTE: These remotes come with a BENELUX region code and only work with devices that come with the same region code
On the image below, you can clearly see the region code near the black arrow. The region code of the Pearl Status is '-00004'. Does your current remote come with the same region code? Then this new remote is compatible with your installation.
Region codes
S10448-00000
INTERNATIONAL code
Switching between SOMloq and SOMloq2 coding
Basically, this remote is ready to be used with an 128Bit receiver (SOMloq2) and the LED light will be orange/amber. By holding down the button longer, the LED light will turn red and the remote will switch to 64Bit (SOMloq1)
If the remote has been coupled to an older SOMloq1 receiver, and you then program it to the new SOMloq2 receiver, it will no longer function on the old receiver.
If you then press down the button for 3 seconds, the remote will go to repeater mode and will transmit 5 times for about 15 seconds long.
If you couple the remote with a SOMloq2 receiver first, then you have to push the button 5 times before you can switch it back to SOMloq1 mode. When doing this, make sure to be out of the reach of your SOMloq2 receiver.
Programming your remote:
Program directly to the receiver. Consult the manual of your controller/opener/receiver.
